Trench Safety: Know the Different Excavation Requirements for your Project

Trench Safety Stand Down week kicks off on June 16, and NAHB is proud to team up with the National Utility Contractors Association (NUCA) and OSHA to raise awareness and prevent injuries and fatalities related to trenching and excavation hazards.

In 2024, 15 workers tragically lost their lives in trench collapses - the same number reported in 2023. These incidents are entirely preventable, and it takes a shared commitment from everyone on the jobsite to ensure a safe work environment for all.

As NAHB celebrates this week's 2025 Trench Safety Stand Down, it is important to know the requirements for the different types of excavation activity for your job. While federal OSHA's excavation standard has been in place for roughly 50 years, builders should also know the separate requirements for certain residential foundation/basement excavations.

According to an agency letter of interpretation, OSHA's requirements for protective systems in excavations do not apply to house foundation/basement excavations when all of the following conditions are met:

• The house foundation/basement excavation is less than seven and one-half feet in depth or is benched for at least two feet horizontally for every five feet or less of vertical height.
• The minimum horizontal width (excavation face to formwork/wall) at the bottom of the excavation is as wide as practicable but not less than two feet.
• There is no water, surface tension cracks, nor other environmental conditions present that reduce the stability of the excavation.
• All soil, equipment, and material surcharge loads are no closer in distance to the top edge of the excavation than the excavation is deep; however, when front end loaders are used to dig the excavations, the soil surcharge load shall be placed as far back from the excavation as possible, but never closer than two feet.
• Work crews in the excavation are the minimum number needed to perform the work.
• The work has been planned and is carried out in a manner to minimize the time employees are in the excavation.

If any one of these conditions are not met, then builders must follow the appropriate OSHA standards. It is also important to note that this exception and the federal OSHA standards themselves may not apply in states with their own occupational safety and health plans.

Trench collapses, or cave-ins, pose the greatest risk to workers' lives. To prevent cave-ins, jobsites should use OSHA's "Slope It. Shore It. Shield It." method:

• SLOPE or bench trench walls,
• SHORE trench walls with supports, or
• SHIELD trench walls with trench boxes

According to the National Utility Contractors Association, most trenching accidents occur in trenches of five to 15 feet deep, and there is usually no warning before a cave-in.

The Trench Safety Stand Down is a good time for home builders to review their procedures for digging and excavating. NAHB has a video toolbox talk that builders can show their workers and subcontractors, and additional resources can be found in the NAHB Trenching and Excavation Toolkit.

For more information on these and other federal OSHA standards, download NAHB's Jobsite Safety Handbook mobile app from both the Apple and Google Play stores.